CRAWER Hyperios LED Headlight Pair for Case/New Holland/Deutz

This pair of CRAWER Hyperios 90mm LED headlights combines low beam and high beam in one unit, supplied with two ND1 adapter cables for a plug-and-play fit on Case, Deutz and New Holland tractors. Each lamp connects via a Deutsch DT 3-pin plug, with the ND1 cable matching the factory harness — no cutting or splicing.

With a 9-32V input, IP67 sealing and full E-mark approval (R112/R10), the CR-3009 draws 55W with low beam active (which includes the high beam circuit) and 30W on high beam alone. The 90mm housing works for bonnet or roof mounting and is CISPR Class 4 rated to keep the tractor’s onboard electronics free of interference.

(See all headlights by clicking here)

Dimensions and installation

• Diameter: 90 mm
• Depth: 106 mm
• Bolt spacing: 84.9 mm, centre-to-centre
• Connector: Deutsch DT 3-pin, with ND1 adapter cable included

Tip: a 2-pin connector for the optional CR-RES02 CAN-bus resistor is built in. Only fit it if your dash shows an error message after installation — it is not always required.

Compatibility

The ND1 adapter is a plug-and-play match for newer Case, Deutz, New Holland and Valtra tractors.

• New Holland: T7, T8 (2016-on — fits lower grille section)
• Case IH, Deutz-Fahr, Valtra: models fitted with the same 90mm housing and Deutsch DT connector

OEM references: Hella 1AL009998001 / 008191051 / 008193027, Claas 0011064040 / 0011064011, Case IH 47573274.

Also suitable for other machines?

The lamp itself is a standard 90mm unit, but the included ND1 adapter cable is wired for Case, Deutz and New Holland harnesses specifically — it will not plug into a Fendt tractor.

If you have a Fendt, see the CR-3009-ND2S instead. If you are not sure which adapter matches your machine, contact us for advice.

Why plug-and-play wiring and IP67 matter

Plug-and-play wiring with the ND1 adapter: Because the ND1 cable is matched to the Case, Deutz and New Holland harness, there is no cutting, splicing or crimping — the original wiring loom stays intact and the install is fully reversible.

IP67 sealing: Front-mounted headlights cop dust, rain and pressure-washing every day in the paddock. IP67 sealing keeps moisture and grime out of the housing so the lamp keeps working reliably season after season.

Frequently asked questions

Why choose this CRAWER Hyperios LED Headlight Pair for Case/New Holland/Deutz at Wattz?

We specialise in LED lighting for agricultural machinery and help you choose the right solution for your setup. Read our customer feedback on Google.

The CR-3009-ND1S is a straightforward LED upgrade for Case, Deutz and New Holland owners who want low beam and high beam in one plug-and-play set. Order today for a clean retrofit with no wiring changes.