Splitter Cable H5/H11

This splitter cable lets you run two H9/H11 bulbs or accessories from a single factory H9/H11 socket, using a 1-female-input to 2-female-output split with a 12 cm cable. It’s a plug-in job — no cutting, crimping or splicing into the loom.

Typical uses include adding a second work light or marker light off an existing H9/H11 headlight circuit, or wiring in an extra CAN-bus accessory without running a new feed back to the harness.

(See all install & connect items by clicking here)

Dimensions and installation

• Connector type: H9/H11 (1x female input, 2x female outputs)
• Cable length: 120 mm (12 cm)

Tip: check that both circuits you’re connecting can share the current draw of the original H9/H11 feed before splitting it.

Compatibility

This splitter fits any application using a standard H9/H11 socket, so it isn’t tied to a specific tractor brand — compatibility depends on the connector type at your existing socket rather than the machine itself.

If you’re unsure whether your socket is H9/H11, contact us before ordering.

Also suitable for other machines?

Yes — since this is a generic H9/H11 socket splitter rather than a machine-specific part, it works with anything using this connector, not just tractors. Contact us if you’re not sure your connector matches.

Why keeping the original connector matters

Matching the original connector:
Splicing wires directly into a factory harness risks a poor connection or water ingress. Using a matching H9/H11 splitter keeps the factory plug intact and adds a second output without cutting into the loom.

Short 12 cm length:
A short cable keeps the splitter tucked close to the original socket rather than left dangling, which reduces strain on the connection and the risk of snagging during operation.

Frequently asked questions

Why choose this splitter cable at Wattz?

We specialise in LED lighting for agricultural machinery and help you choose the right solution for your setup. Read our customer feedback on Google.

Keeping a ZA2022 splitter on hand means adding a second H9/H11 load never means splicing into the factory loom. Order today for a clean, plug-in way to add an extra light or accessory.